Coin System Accessory
s² SSD
The NRI s² SSD is the standard 3-way sorter series for the G-13.mft and v² colibri coin validators.
It reliably sorts the coins accepted by the coin validator into a downstream coin payout system (e.g. hopper) or into the machine cashbox via up to three sorting paths.
Available in four versions so your coins are always, on the right track.
Key Advantages:
- High reliability coin sorting due to NRI solenoid technology
- Various mounting positions thanks to optional mounting frames
- Full level sensing for payout system connected
- For G-13.mft / v² colibri top entry & front entry versions
- Any sorting chute can be utilized as a cashbox chute
- Customized coin return:
- front return for G-13.mft / v² colibri front entry model
- bottom in-line return for G-13.mft / v² colibri top entry model (return chute in-line with three sorting chutes)
- bottom parallel return for G-13.mft / v² colibri top entry model (return chute in front of or behind the right-hand sorting chute)
- Power is supplied either through coin validator or via separate 2-pole screw terminal
- Optional lines for full signal from payout unit connected
Dimensions (H x D x W in mm):
- s² SSD-3001: 57 x 65 x 115 (bottom parallel return, front)
- s² SSD-3002: 57 x 65 x 149 (bottom in-line return)
- s² SSD-3003: 57 x 65 x 115 (bottom parallel return, rear)
- s² SSD-3004: 57 x 65 x 110 (without return chute)
Coin processing:
- Diameter: 15–31.5mm, middle sorting chute up to 33.0mm
- Thickness: 1.5–2.5mm, depends on mounting position (in NRI mounting frame up to 3.3mm)
Interfaces supported:
- Coin validator/sorting interface version depends on the coin validator model
Operating temperature:
- 0°C to 60°C
Supply voltage:
- 12–24V DC
Power connection:
- Through coin validator
- Via separate connector
Return Chute Arrangements
- s² SSD-3001, bottom parallel return (return chute in front of right-hand sorting chute)
- s² SSD-3002, bottom in-line return (return chute next to right-hand sorting chute)
- s² SSD-3003, bottom parallel return (return chute behind right-hand sorting chute)
- s² SSD-3004, without return chute (for front entry validator versions)
Mounting Devices
- Mounting frame for G-13.mft/ v² colibri top entry model
- Holding plate for G-13.mft/ v² colibri front entry model